Part No. 26125 Rev. K August 2018
- 12 -
Inline 4000 Series Cabinets
Preparation
cont.
REFRIGERATED CABINETS
-
OPERATION
Defrost Cycle
Note that the defrost times are set from when the cabinet is first turned on. If
they are required at a particular time, you must turn on the cabinet four hours
before the first defrost required. The cycles will then occur every four hours,
provided the cabinet is not switched off.
Each defrost cycle terminates as soon as the temperature of the evaporator fins
rises to a level indicating that all ice has melted.
This active defrost system improves the energy efficiency of the cabinet, and
minimises temperature fluctuations.
Load Cabinet
Load the cabinet with pre-chilled product, from either the front or rear doors.
The cabinet is designed to maintain the temperature of pre-chilled product at
between 2
and 4
C. It is not a refrigerator, and consequently, if warm product
is introduced, there could be some delay before the operating temperature falls
to the normal operating level.
Loading
Restrictions
It is important to leave adequate free space for
the refrigerated air to circulate within the
cabinet.
Product should be kept clear of the shaded
areas, shown in the picture.
A minimum clearance of 40 mm should be
maintained below the shelves and the top of
the cabinet.
The air grills at the front and rear of the cabinet
must not be covered at all.
Close all Doors
It is important to keep all cabinet doors closed. If doors are not fully closed, an
even temperature will not be maintained within the cabinet.
Turn on Lights
When ready for service, turn on the cabinet lights.
