Recyclation and Waste Disposal Note (European Union)
Electrical/electronic equipment marked with the crossed-out waste bin symbol must not be discarded in the domes-
tic waste; it should be disposed of via the appropriate specialised disposal system.
In the countries of the EU (European Union) electrical/electronic devices must not be discarded via the
normal domestic waste system (WEEE - Waste of Electrical and Electronic Equipment, Directive 2002/96/
EG). You can take your unwanted equipment to your nearest public collection point or recycling centre,
where it will be disposed of in the proper manner at no charge to you. By disposing of your old equipment in a
responsible manner you make an important contribution to the safeguarding of the environment!
Declaration of Connformity CE (European Union)
Hereby, Pelikan Daniel declares that these FOXY UBEC 3A and 6A voltage regulators are in compliance with
the essential requirements as laid down in the directive concerning electro-magnetic compatibility (directive
89/336/EEC).
The full text of the Declaration of Conformity is available at www.PelikanDaniel.com.
Guarantee
The Pelikan Daniel products are covered by a guarantee which fulfils the currently valid legal requirements in your
country. If you wish to make a claim under guarantee, please contact the retailer from whom you first purchased the
equipment. The guarantee does not cover faults which were caused in the following ways: crashes, improper use, in-
correct connection, reversed polarity, maintenance work carried out late, incorrectly or not at all, or by unauthorised
personnel, use of other than genuine Pelikan Daniel accessories, modifications or repairs which were not carried out
by Pelikan Daniel or an authorised Pelikan Daniel, accidental or deliberate damage, defects caused by normal wear
and tear, operation outside the Specification, or in conjunction with equipment made by other manufacturers.
Please be sure to read the appropriate information sheets in the product documentation!
4. Electric powered with an ESC featuring BEC:
you have to disable the internal BEC in the ESC
first. Remove the pin of the red wire (+) from the ESC servo connector and insulate it with a piece of
shrinking tube. The connection of the UBEC is the same as above then.
Note:
In order to minimize any possible interference install the UBEC in your model at the distance
at least 5 cm from the receiver. If you still encountered some troubles (esp. with AM/FM 27, 35 or 40
MHz radios) you can supress the interference by installing a ferrite ring on the UBEC output cable.
Address of the Local Distributor
RoHS
black
red
BATTERY
6...25 V DC
ESC
OPTO
UBEC
Batt.
Throttle
RECEIVER
-
+
S
-
+
S
ESC
BEC
UBEC
Batt.
Throttle
RECEIVER
-
+
S
-
+
S
X
DISCONNECT (+) WIRE!
black
red
black
red
UBEC
Batt.
RECEIVER
-
+
S
BATTERY
6...25 V DC
BATTERY
6...25 V DC
PELIKAN DANIEL
Doubravice 110 | 533 53 Pardubice | T.: +420 466 260 133 | F.: +420 466 260 132
e-mail: [email protected]
Manufactured in China for Pelikan Daniel
