after this many seconds
attempt to create connection
Dividing packets
Enable custom packetization logic
packet dividing turn on
Use UDP instead of TCP
using UDP instead TCP
Number of characters to
accumulate before sending
TCP/UDP packet( 128Max)
number of characters which will be send in one
message (maximum 128) – data will be also send if
the set time passed or the set character come
Number msec to wait for
accumulated characters:
0 waits forever
the time after which the received characters are
sent.
0 signs that the data will not be sent dependently on
the time.
Flush TCP/UDP frame when this
character is received (Enter NA to
disable)
Decimal character value (ASCII) after which
reception will be sent. If the „NA“ is input no
character is selected. For example CR (carriage
return) is 13.
By pressing the button „Submit New Settings“ the selected settings are saved.
Serial line basic setup is shown in the following picture.
.
Data Port Settings
RS-485 Half Duplex – half duplex two wires RS485
RS-485 Full Duplex – full duplex four wires RS485
7
www.
foxtron
.eu
