4. Radiator Of Halo-6000
The radiator can be mounted in different places to the generator, so after the installation,
the operator should do the heat balance test of the UAV. When do the heat load testing of the
generator, the temperature of the head should be kept between 70
℃
to
9
0
℃
,
and be care for
temperature changing
caused by
season changing.
Too low temperature for too long will
accelerate the wear, and high temperature is easy to make the coolant boiling and
cylinder
scoring.
Halo-6000
has the function
of
monitor
ing
the temperature of the engine and motor, when
the water temperature is over 95
℃
, the generator will lower the throttle about 20%, when it's
over 105
℃
, the generator will shut down for protection; when the
motor
temperature is over
135
℃
,
the generator will lower the throttle about 20%, and when it's over 145
℃
, the generator
will shut down for protection.
5
.
Cooling System
Of Halo-6000
Halo-6000 applies water-cooling system, so if it is used in an environment that is under
0
℃
, an antifreeze should be added. For the first time use and refill, should exhaust the air.
The air exhausting steps can be acquired from Foxtech. Air in the cooling pipe will make the
coolant boiling
, even worse, cylinder scoring.
Please make sure that there is no air in the
cooling pipe before each takeoff
and check the sealing of the cooling system to ensure safety.
6
.
Air Filter
Of Halo-6000
The engine's air filter system can filter out particles of a certain size, but long-term use or
severe dust conditions can cause the air filter to clog, decreasing the engine air intake, which
in turn reduces the engine output. If you find that the engine output decreases, please clean or
replace the air filter in time.
Halo-6000 EFI Generator Usage Precaution
©2022 FOXTECH All Rights Reserved 4
