©
2017 FOXTECH All Rights Reserved
12
GAIA 160HY-Hybrid DJI A3 PRO
User Manual
Takeoff and Landing
Takeoff
Follow the steps below to Takeoff:
1. Push the primer pump several times until fuel supply pipe is filled with gasoline(Fig.1).
2. Check the inlet filter if it is clogged(Fig.2).
3. Power on and switch the three-position switch to "idle". Make sure the status lamp on NOVA controller is
"green".
4. Close the Choke Lever (Fig.3), a.Push hard the starter to NOVA, b.Push the start button for seconds.
Disconnect starter from NOVA.(For a warm start, choking may not be necessary.)
5. Open the Choke(Fig.3). Push start button for 2~3seconds. Pull the starter until hearing running
noise(Fig.4).
6. Switch the three-position switch to “run”, and monitor the UAV input voltage. Voltage should be at 49±1V.
7. Run NOVA for 1 minute for warming up.
8. Launch the DJI GO app and enter the Camera View.
9. Ensure that the aircraft is in P-mode.
10. Go through the pre-flight checklist.
11. Push both sticks to the bottom inner or outer corners to start the motors. Once the motors have started
spinning, release both sticks simultaneously.
Fig.1
Fig.3
Fig.2
Fig.4
