Foxpro WILDFIRE, Instruction Manual

Page: 10 / 20

Page | 10
4. Press P1 a final time to lock in your preset.
3.9 FOXBANG
When enabled, FOXBANG will play your first preset sound upon discharging of
your firearm. For example, if you normally switch to a preset of a ki-yi or pup
distress after making a shot, FOXBANG can automatically play that preset for
you without the need for intervention. FOXBANG has 5 sensitivity levels which
are set via the TX-9 transmitter (lowest, low, medium, high, and highest).
FOXBANG status will be shown in the upper left-hand corner of the display
(see the image above) .
Turning FOXBANG On and Off
1. To turn FOXBANG on, simultaneously press the Sound Up and Down
buttons on your TX-9. Repeat this step to turn FOXBANG off.
NOTE: When you activate FOXBANG it will automatically use the previous
sensitivity setting. The factory default sensitivity is medium. You may need to
adjust this in order to get the right setting for your firearm. If you are using a
large caliber (.30-06), you would want to select a lower sensitivity. If using a
smaller firearm (such as .17HMR or .22), use the higher sensitivity.
Medium
settings should be suitable for .17 Fireball, .223, .22-250, etc.
Selecting FOXBANG Sensitivity
1. Press and hold Sound Up and Down on the TX-9 for 3 seconds.
2. Use the Volume Up and Down buttons to select your desired
sensitivity.
3. Press the Send button to lock this setting in.
NOTE: An unintended and unavoidable consequence of adjusting the