Foxpro Hammer Jack 2, Instruction Manual

Page: 21 / 24

21
11. Changing the Channel of Operation
Prior to attempting remote controlled operation, it is important that you first verify that both the
HammerJack2 and TX433 remote are set to operate on the same channel. If the two devices are not on the
same channel, then radio communication will not be possible.
HammerJack2 Channel of Operation:
1. Connect the caller to a computer as described in Section 10.
2. Download the Programming Utility also outlined in Section 10.
3. While the caller is hooked up to your computer, open the Programming Utility.
4. Click the “Set Channel” button located at the bottom right of the program.
5. A pop- up window will appear titled “Set Radio Channel.”
6. Your current channel will be shown with a box labeled “New Radio Channel” below it.
7. Enter your new channel in that box (1-3).
8. Clic k “Save” and a pop - up box will display “Channel updated successfully.”
9. Follow the steps in Section 8-17 to change the channel on your remote control.
12. Maximizing Remote Range
Remote range can be affected by many factors. Some of these factors can be controlled while others
cannot. In order to achieve the best possible remote range with your HammerJack 2 digital game call
system, it is recommended that the following points be observed:
•
Always use a high-quality alkaline or lithium battery in the remote.
•
Always maintain clear line of sight between the remote control and the HammerJack 2. Any
obstructions
— no matter how significant or insignificant — can adversely affect the radio signal.
•
Try to keep the remote control approximately six inches away from your body, gun barrel, and
metal shooting sticks as these things can detune the remote control.
•
Hold the remote control vertically with the antenna pointing skyward (see image below):
•
Avoid using the device remotely when you are near power lines, cellular phone towers, and
radar (such as near airports or military installations).
•
Try to elevate the caller off of the ground by approximately three feet. This can greatly maximize
your overall remote-control range.
•
Try to avoid situations where the HammerJack 2 is placed at a lower elevation than the remote
control
— the caller should always be higher.