Foxfury Lighting Solutions Taker B10, Product Manual

Page: 6 / 12

6
1. Begin with the Picatinny Mount. Using the provided 2mm Hex Key, loosen
ONLY two (2) of the Mount Screws (see “Taker B10 Reference Guide”
on pg. 3 for location). NOTE: The Mount Screws do NOT need to be
completely removed in order to mount.
2. Position either side of the Picatinny Mount onto the Picatinny C-Clamp.
Then position the opposite side onto the Picatinny Rail. Then, re-tighten
the two (2) Mount Screws that were loosened in Step 1.
OPERATIONAL MODES
For MOMENTARY mode: Press and hold the Power/Mode Switch. While
the Switch is depressed, the flashlight will operate in HIGH mode. When
the user removes pressure from the Switch, the light will turn OFF.
For HIGH mode: Press the Power/Mode Switch two (2) times in rapid
succession. The light will remain in HIGH mode.
For LOW mode: While in HIGH mode, press and hold the Power/Mode
Switch for two (2) seconds. The mode will change to a LOW setting.
For TURBO-STROBE
™
: Press the Power/Mode Switch three (3) times in
rapid succession.
For OFF or EXIT a mode: Press the Power/Mode Switch once. Then,
continue following the directions above to progress to desired mode.
NOTE: The light does not retain the mode in memory. Once you turn the
flashlight ON, you will have to re-select the mode you desire.
ASSEMBLING MOUNT TO CLAMP
1
1
2
2