5
60
Intel
®
Rapid Storage Technology enterprise
The Intel
®
Rapid Storage Technology enterprise technology supports RAID 0 ,RAID 1,
RAID 5, and RAID 10 (0+1) functions. It allows you to get high performance with fault
tolerance, big capacity, or data safety provided by different RAID functions.
In this section, we will use four SATA hard disks as an example to guide you how to
configure your RAID system. There are two 149.0GBs and two 74.5GBs. A creation of
second volume will also be well described.
In each screen, there is also a message bar about each key’s function, such as <Tab>,
<Enter>, <Del>...etc. it is to help making your selection easier.
The topic will be introduced :
Installing a new Windows XP in a brand new RAID system.
Steps to Install Serial ATA Hard Disks :
1. Install SATA hard disks into the drive bays.
2. Connect one end of the SATA cable to motherboard’s SATA connector, and the
other end to SATA hard disk.
3. Connect SATA power cable to the power connector of SATA hard disk.
Before installing the SATA hard disks, make sure to turn off the computer
and unplug the power cord from the power outlet to prevent damage to the
hardware.
C
A
U
T
IO
N
!
■
Both AHCI and RAID modes need to install
Intel
®
Rapid Storage Technol
-
ogy enterprise driver.
driver.
■
Set SATA mode in BIOS to AHCI, you can skip RAID BIOS creation steps,
but the software driver installation of
Intel
®
Rapid Storage Technology
enterprise
shall follow the same rule as described for RAID.
W
AR
NING!
