10
minimum distance 20cm between the radiator & your body.
This device is intended only for OEM integrators under the following conditions:
1) The antenna must be installed such that 20 cm is maintained between the antenna
and users, and 2) The transmitter module may not be co-located with any other transmitter
or antenna.
As long as 2 conditions above are met, further transmitter test will not be required.
However, the OEM integrator is still responsible for testing their end-product for any
additional compliance requirements required with this module installed
IMPORTANT NOTE:
In the event that these conditions can not be met (for example
certain laptop configurations or co-location with another transmitter), then the FCC
authorization is no longer considered valid and the FCC ID can not be used on the
final product. In these circumstances, the OEM integrator will be responsible for
reevaluating
the end product (including the transmitter) and obtaining a separate FCC
authorization.
End Product Labeling
This transmitter module is authorized only for use in device where the antenna may be
installed such that 20 cm may be maintained between the antenna and users. The
final end product must be labeled in a visible area with the following: “Contains FCC
ID: MCLJ20H086”. The grantee's FCC ID can be used only when all FCC compliance
requirements are met.
Manual Information To the End User
The OEM integrator has to be aware not to provide information to the end user
regarding how to install or remove this RF module in the user’s manual of the end
product which integrates this module.
The end user manual shall include all required regulatory information/warning as show
in this manual.
For Taiwan
警語：
(
電信管制射頻器材使用
)
經型式認證合格之低功率射頻電機，非經許可，公司、商號或使用者均不得擅自變更頻
率、加大功率或變更原設計之特性及功能。
低功率射頻電機之使用不得影響飛航安全及干擾合法通信；經發現有干擾現象時，應立
即停用，並改善至無干擾時方得繼續使用。前項合法通信，指依電信法規定作業之無線
電通信。低功率射頻電機須忍受合法通信或工業、科學及醫療用電波輻射性電機設備之
干擾。
Note: 1.
本模組於取得認證後將依規定於模組本體標示審驗合格標籤
2.
系統廠商應於平
台上標示「本產品內含射頻模組
: XXXyyyLPDzzzz-x (NCC ID)
」字樣
Europe – EU Declaration of Conformity
This
device
complies
with
the
essential
requirements
of
the
R&TTE
Directive
1999/5/EC.
The
following
test
methods
have
been
applied
in
order
to
prove
presumption
of
conformity
with
the
essential
requirements
of
the
R&TTE
Directive
1999/5/EC:
‐
EN
60950
‐
1:
2006+A11:2009+A1:2010+A12:2011
Safety
of
Information
Technology
Equipment
‐
EN
62311:
2008
Assessment
of
electronic
and
electrical
equipment
related
to
human
exposure
restrictions
for
electromagnetic
fields
(0
Hz
‐
300
GHz)
(IEC
62311:2007
(Modified))
EN
300
328
V1.9.1
‐
Electromagnetic
compatibility
and
Radio
spectrum
Matters
(ERM);
Wideband
Transmission
systems;
Data
transmission
