3
41
SuperIO Configuration
► OnBoard Floppy Controller
This item is used to enable/disable Floppy Controller.
► Serial Port1 Address
This item is used to assign the I/O address and interrupt request (IRQ) for the onboard serial
port 1.
► Serial Port2 Address
This item is used to assign the I/O address and interrupt request (IRQ) for the onboard serial
port 2.
► Serial Port2 Mode
This item is used to set the mode for the onboard serial port 2. The available settings are :
[IrDA] : An IrDA device for maximum 115200 bit/s.
[ASK IR] : A faster IrDA for 1152000 bit/s.
► Serial Port2 Duplex Mode
It is used to set the transfer mode of the onboard serial port 2. The available settings are : [Half
Duplex], [Full Duplex].
CMOS Setup Utility - Copyright (C) 1985-2008, American Megatrends, Inc.
SuperIO Configuration
SuperIO Configuration
Help Item
OnBoard Floppy Controller
[Enabled]
Allows BIOS to Enable
Serial Port1 Address
[3F8/IRQ4]
or disable floppy
Serial Port2 Address
[2F8/IRQ3]
controller.
Serial Port2 Mode
[IrDA]
Serial Port2 Duplex Mode
[Half Duplex]
↑↓←→:Move Enter:Select +/-/:Value F10:Save ESC:Exit F1:General Help
F9:Optimized Defaults
[Enabled]
