5
2.
Pull up the parking brake.
3.
Remove the key from the ignition. The engine will keep running.
4.
Exit the vehicle and close the door after taking Step# 3. Then the engine will shut down and the reservation mode is set up.
Important
: Reservation mode must be set up every time before exiting manual transmission cars in order to remote
start. Reservation mode will be activated only when the engine has been running over 5 minutes, because of the turbo timer
function. If the Turbo Timer function is defaulted as 120 sec. (or 180 sec.), the remote start function can be activated after the
turbo timer is off.
Important requirements to activate the reservation mode
:
1.
The transmission gear must be placed in the
neutral
position.
2.
The hand brake must be pulled up.
3.
Do not set the reservation mode when people are in vehicles.
4.
Do not activate the remote engine start when people are in vehicles
5.
The remote engine start will only be activated when the system is armed.
Cancel the Reservation Mode
The reservation mode will be cancelled if the following cases happen.
1.
The parking brake released when the engine is running.
2.
Press button (3) for 3 seconds
between Step 3 and 4 during defaulting the reservation mode.
3.
The valet mode applied after completing the reservation mode.
Doors opened after completing the reservation mode without remote engine start.
Factory Alarm Disarm Output
If the vehicle has the factory fitted alarm, Use this wire to override the factory alarm before activate the system.
Important
:
The factory fitted alarm must have the device of an input wire to receive signals from the system.
Immobilizer By-pass Output:
Nowadays, most of brand new cars have the immobilizer transponder device to enhance the security.
For these kinds of vehicles, The system has the immobilizer by-pas output.
Before apply remote engine start, the system will send constant signals to disable the factory immobilizer. After the remote engine
start succeeds, the system will stop sending signals.
After the engine stops running during the reservation mode, the system will stop sending signals to disable the factory
immobilizer.
Important
: F
actory immobilizer device must have an input wire to receive signals from the system.
Optional Programming Features
The system has the additional features that can fit in different types of vehicles and your customized needs.
Read the below programming functions carefully to have the right options programmed for your vehicles and your needs.
a)
Under the disarm mode, open car door, and switch the ignition on-off, on-off, on-off and then stay On.
b)
Siren will chirp 2 seconds and LED will be on for 2 seconds to confirm entering the programming option mode.
c)
To choose the function # 1 - 21, Press button (1) as many as its function # is indicated as listed below within 10 seconds after
taking step# b. Each time you press button (1), the single short chirp shall follow up.
For example, if you want to choose # 11 Last Door Arming, press button (1) 11 times.
d)
To confirm the selected mode, Press button (2). Siren will chirp as many as you press button (1) in step # C to show the
function you chose.
For example, if you press button (1) 11 times in step # C, 11 single short chirps will follow up.
e)
Now, you can make the selected mode programmed as factory default, default #1 or default #2 by pressing button (1), (2) or
(3).
When you press button (1), a single chirp will come out. Button (2) to program Default #1 of each function, two chirps and
button (3) to program Default #3 of each function, three chirps to indicate the selected default programmed.
The system will quit the programming option if there is no action made within 10 seconds your previous action taken or the
ignition is off.
Programming Option Reset
You can apply the programming Option reset function to reset all options back to the factory defaults. Followings are the
procedure.
