mx-c Owner’s manual |
p/n: 605-00-093 reV a
8
p/n: 605-00-093 reV a
| mx-c Owner’s manual
9
bleeDINg The MX-C
as a rule Of ThuMb, uNThreaD The bleeD sCrew befOre every
raCe . DO ThIs ONly wheN The fOrk Is aT rOOM TeMperaTure aND
fully eXTeNDeD . ThIs relIeves The eXCess pressure ThaT NOr-
Mally buIlDs up IN The fOrk Over TIMe .
bleeding prOcedure
1 . place the bike on a stand so that the front wheel is off of the ground .
2 . make sure the top cap is clean before removing bleed screw .
3 . remove the bleed screw from the top of the fork using a flat blade screwdriver . (You might hear air escape
when the o-ring seal is released) .
4 . check o-ring on screw for any dirt, cracks or tears and replace or clean as needed
5 . reinstall bleed screw .
IT Is NORMAl TO heAR AIR esCApe wheN The Bleed sCRew Is
uNThReAded. IT dOes NOT MeAN ThAT YOuR FORK Is deFeCTIve OR
dAMAged IN ANY wAY.
TuNINg NOTes:
The MX-C RequIeRs speCIAl equIpMeNT TO ACCess ANd AlTeR
The INTeRNAl pARTs OF YOuR CARTRIdge. dO NOT TRY TO OpeN
YOuR FORK. FOR TeChNICAl suppORT CONTACT A FOX RACINg shOX
CeRTIFIed TeChNICIAN.
