fox fury TAKER B10, Product Manual

Page: 4 / 7

6
7
1. Begin with the Picatinny Mount. Using the provided 2mm Hex Key, loosen
ONLY two (2) of the Mount Screws (see “Taker B10 Reference Guide”
on pg. 3 for location). NOTE: The Mount Screws do NOT need to be
completely removed in order to mount.
2. Position either side of the Picatinny Mount onto the Picatinny C-Clamp.
Then position the opposite side onto the Picatinny Rail. Then, re-tighten
the two (2) Mount Screws that were loosened in Step 1.
OPERATIONAL MODES
For MOMENTARY mode: Press and hold the Power/Mode Switch. While
the Switch is depressed, the flashlight will operate in HIGH mode. When
the user removes pressure from the Switch, the light will turn OFF.
For HIGH mode: Press the Power/Mode Switch two (2) times in rapid
succession. The light will remain in HIGH mode.
For LOW mode: While in HIGH mode, press and hold the Power/Mode
Switch for two (2) seconds. The mode will change to a LOW setting.
For TURBO-STROBE
™
: Press the Power/Mode Switch three (3) times in
rapid succession.
For OFF or EXIT a mode: Press the Power/Mode Switch once. Then,
continue following the directions above to progress to desired mode.
NOTE: The light does not retain the mode in memory. Once you turn the
flashlight ON, you will have to re-select the mode you desire.
The flashlight is easily securable and removable by using the Release Lever.
TO INSERT THE FLASHLIGHT INTO THE HOLDER:
INSERTING/REMOVING FROM THE
HOLDER
ASSEMBLING MOUNT TO CLAMP
1. Insert the flashlight by pushing it into the beveled opening on the front of
the Holder.
2. Once locked, the Release Lever falls into a groove on the handle, securing
the flashlight in place.
TO REMOVE THE FLASHLIGHT FROM THE HOLDER:
1 2
1. Press and hold the Release Lever.
2. While keeping the Release Lever pressed, pull flashlight out of the Holder.
1
1
1
1
1
2
2
2
2
2