6. The front crossbar suction foot group can be
rotated to adjust the angle, as shown in Figure ⑦
to adapt to different vehicle roof surfaces.
5. The empty chute on the back of the crossbar should be covered with decorative
strip. when the position of the suction foot group is close to the inner side of the
crossbar and the inner decorative strip is too long, you can cut the inner decorative
strip to a suitable length. cover the chute, and finally install the side cover of the
crossbar, as shown in Figure ⑥.
Rotating to adjust the angle
of the suction foot group
Front crossbar
Rear crossbar
Cut the decorative strip short
⑥
⑦
20
Installation Notes