Four winns 310 Horizon, Owner'S Manual

Page: 116 / 172

Owner’s Manual Page Upholstery - Section N
G. Motorhood Walk-over Backrest and Cushion
(Fill-in)
A.backrest.and.cushion.are.removable.to.allow.walk-
over.access.from.the.swim.platform.to.the.cockpit..
See.Figure.N14..To.secure.the.motorhood.walk-over.
backrest and cushion fill-in, place the male end of the
hold.down.into.the.female.portion.of.the.assembly..
Push down to ensure the cushion is firmly seated.
Place the backrest portion of fill-in against the fiber -
glass.portion.of.the.sunpad.base..See.Figure.N15..
Note.the.sew.pattern.of.the.cushion.should.match.the.
port.and.starboard.cockpit.seat.cushions..To.prevent.
a.possible.man.overboard.situation,.make.sure.the.
swim.platform.area.is.unoccupied.and.the.motorhood.
walk-over backrest and cushion fill-in is in place
before.each.cruise.
Figure N14: Walk-Over Transom
Figure N15: Walk-Over Backrest Door & Fill-In Cushion
Prevent falls overboard. Secure the.motorhood.
walk-over backrest and cushion fill-in and stay
inside cockpit while underway.
To prevent personal injury, swim platform
must not be occupied and the.motorhood.walk-
over backrest and cushion fill-in must be in
place while engines are running.
To prevent personal injury, DO NOT sit on the
the.motorhood.walk-over.backrest.portion.of.
fill-in .
NOTICE
If towing at highway speeds, be sure
the fill-in cushions and backrests are properly
secured (locked in position). Air currents
(created within the interior when traveling) will
lift the cushions/backrests up and out of the
boat under certain conditions; especially when
semi-trucks or other large vehicles pass by.
H. Stern Loungers (Sunpads)
The.310.Horizon
™
.models.are.equipped.with.unique.
stern.seats.which.convert.to.two.separate.loungers.or.
sunpads..Storage.compartments.are.located.beneath.
the.aft.lounger.cushions..See.Figure.N16,.N17.and.
N18.
Falling overboard can cause serious injury or
death. Do not sit in platform lounging seats
when engine is running.
Figure N16: Separate Sunpads in Flat Position
Hold Down
Assembly