Burner connections
1
.
Make sure the valve connections are securely fastened to the burner and the tank.
2
.
Visually check the connection between the burner / venturi tube and orifice.
3
.
Make sure the burner/ venturi tube fit over the orifice.
4
.
Please refer to diagram for proper installation (Figures 1 and 2). 5, If the burner/venturi tube
does not rest flush to the orifice, as shown, please contact 1-855-600-9294 for assistance.
Tank/Gas Line Connection
1
.
Make 2-3 oz. of leak detection solution by mixing one part liquid dishwashing soap with
three parts water.
2
.
Make sure regulator/control knob is in the “OFF” position (Figure 3).
3
.
Apply the leak detection check solution on all “X” location (Figure 1 and 2)
a. If any bubbles appear, remove the LP gas tank and reconnect, making sure the connection is
secure.
b. If you continue to see bubbles after several attempts, remove the LP gas tank per
“Disconnecting LP Gas Tank” section, and contact 1-855-600-9294 for assistance.
c. If no bubbles appear after one minute, turn regulator/ control knob to the “OFF” position,
wipe away solution and proceed.
7
X
X
