Four E's Scientific Ironman III, Operating Instructions Manual

Page: 13 / 29

5.8. Setting the dry-start protection alarm
When the device is started, the dry-burning protection function
is automatically turned on.
When the system detects that the inner pot is in a dry state, it
will stop heating and sound analarm.
6. CALIBRATION
6.1. Calibration condition
To ensure accurate calibration results, good calibration conditions
are required:
1. The accuracy of the thermometer should be more than 10 times
that of the water bath display.
2. At a stable ambient temperature (+/-1°C) without air convection.
3. Wait for the liquid to reach the calibration setting temperature
and stabilize for 30 minutes before calibrating.
4. Add water to the water bath to 50 mm above the tray, and place
the thermometer in the center of the water bath, 40 mm away
from the tray.
12
Operation Display
When the countdown is 0, it displays ---- and the
current temperature, and the countdown is off; when
the countdown is not 0, it displays the length of the
countdown and the current temperature.
The first two digits are flashing; enter the state of
setting countdown hours
Set countdown hours
The last two digits are flashing; enter the state of
setting countdown minutes
Set countdown minutes
Press the to save the setting, or the setting is
invalid. The countdown timer will begin once you save
the setting. The setting will exit automatically after 10S
without operation
----
current temperature
00
:
00
current temperature
01
:
00
current temperature
01
:
00
current temperature
01
:
10
current temperature
01
:
10
current temperature