Remove pump as described in
finish
section.
Fill tank with tap water. Replace pump and turn
clockwise to tighten. Agitate tank to rinse chemical off
tank wall and pump.
Remove pump and empty contents into gravel or bare soil.
Refill tank with tap water.
Check to be sure pump is free of debris and place pump
into tank. Turn handle clockwise to tighten pump.
Pressurize tank. Follow all instructions in
pressurize
section.
Point nozzle away from you and spray for
approximately 30 seconds to clean hose and shut-off.
Release pressure as outlined in
operating
and
finish
sections.
Empty contents as in step 3.
Repeat steps 4 thru 8 until thoroughly cleaned. Note: It
is best to keep 2 sprayers: One for herbicides and one
for other products, such as fertilizers or insecticides.
CLEANING SPRAYER
SPRAYER STORAGE
SPRAYER MAINTENANCE
1.
2.
3.
4.
5.
6.
7.
8.
9.
1.
2.
3.
4.
Pump should be periodically oiled by dropping 10 to 12
drops of light oil down pump rod through opening in cover.
If nozzle clogs: remove nozzle assembly, disassemble nozzle
and clean openings of any obstructions.
Never use any tool to remove pump if there is pressure in
sprayer.
Sprayer tank should be hung upside down, with pump
removed, in a warm dry location.
Do not store or leave any solution in tank after use.
Store in a warm dry location out of direct sunlight.
KEEP SPRAYER OUT OF REACH OF CHILDREN.
1.
2.
3.
IMPORTANT! Always ensure pressure is released from
tank before filling or servicing.
To release pressure, press
button on shut-off until the unit stops spraying. Then, and
only then, it is safe to remove pump.
1.
2.
Remove pump by turning pump handle counterclockwise.
Fill tank to desired level (always refer to chemical
manufacturer for proper mixture)
Place pump into tank opening and turn handle
clockwise to tighten.
3.
PRESSURIZING:
1.
2.
Make sure shut-off lock is not engaged (if shut-off
lock is engaged while pressurizing, the unit will
immediately start spraying)
Pressurize sprayer by pumping handle in a smooth
up and down motion. When desired pressure is
achieved, lock handle onto pump.
SPRAYING:
1.
2.
Point nozzle away from you. Press shut-off button to
begin spraying. Release button to stop spraying. When
using adjustable nozzle, adjust spray pattern by turning
nozzle tip. (Note: Flat fan nozzle is not adjustable).
For continuous spraying, push lock onto shut-off button.
FINISH:
1.
2.
Direct nozzle away from you and press button on shut-off
until unit stops spraying (this will release pressure in tank).
Turn pump handle counterclockwise to remove pump.
OPERATING INSTRUCTIONS
1-800-311-9903
1-800-311-9903
If you have any problems with, or have any questions about your sprayer,
BEFORE YOU
RETURN IT TO THE STORE, CALL OUR TOLL FREE CUSTOMER SERVICE CENTER AT:
1
171015
Check Valve
2
171653
Nozzle Cap
3
178354
Shut-off Assembly
4
180284
Fan Nozzle
5
180287
Parts / Instructions
6
180426
1 Gallon Tank-Yellow
6
180425
1 Gallon Tank-Natural
6
180477
2 Gallon Tank-Yellow
7
180299
Pump Gasket
8
180300
O-Ring, Pump
9
180305
Pump Assembly
10
180308
Hose 32”
KEY NO. PART # DESCRIPTION
KEY NO. PART # DESCRIPTION
11
178363
Extension Curved
12
180332
Parts Kit
13
1783541 Hose / Shut-off Nut
14
1785096
O-Ring, Nozzle End
15
1785097
O-Ring, Base End
KEY NO. PART # DESCRIPTION
