04385
Page 1
02/09/2016
REV E
INDUSTRIAL - AQUEOUS PARTS CLEANER
EM5000
I. Introduction
A. Manufacturer’s Statement
This manual will provide you with important information about the Aqueous Parts Cleaners and will
instruct you on how to use this equipment in a safe manner.
The information contained in this manual is necessary for the safe, proper setup and operation of
your Aqueous Parts Cleaner.
Keep this manual, along with the Material Safety Data Sheets (MSDS) for the solution in use, within
easy reach of the operator of this parts cleaner.
The equipment described in this manual is subject to change. The manufacturer reserves the right to
change equipment at any time as part of normal product improvement. Some improvements may
have been made after this manual was printed. For the latest information on your equipment, contact
the manufacturer.
B. General Information
CAUTION
READ AND UNDERSTAND ALL LABELS, MSDS, AND
THIS INSTRUCTION MANUAL BEFORE USE.
The Industrial Aqueous Parts Cleaner is an economical, safe, and innovative system designed to
clean parts, using an aqueous based solution. Aqueous solutions, when used to clean grease and oil,
must be disposed of properly. Consult your local environmental management agency for additional
guidance and other potentially hazardous materials compliance requirements.
Install your parts cleaner on a flat, level surface in an area provided with adequate ventilation. Avoid
repeated or prolonged breathing of vapors. Do
NOT
use compressed air to dry parts as this may
cause a high concentration of vapors in the immediate area. Local exhaust ventilation should be used
in areas of high vapor concentration. Provisions for determining and maintaining adequate ventilation
are the responsibility of the operator.
Make sure the parts cleaner is connected to a properly grounded power source. Check serial plate for
power requirements.
Do
NOT
allow the parts cleaner to operate unattended.
OPERATION & INSTRUCTION MANUAL
