Product Overview
December 2008
© 2008 Foundry Networks, Inc.
2 - 7
Figure 2.4 shows the FSX 800 Chassis and the slots into which you can install the various modules and power
supplies.
Figure 2.4
FSX 800 Chassis Slots
Figure 2.4 also shows an electrostatic discharge (ESD) connector, into which you can plug an ESD wrist strap to
ground yourself while handling and installing modules.
WARNING:
For safety reasons, the ESD wrist strap should contain a series 1 meg ohm resistor.
FSX 1600 Chassis
There are two versions of the FSX 1600 chassis:
•
FSX 1600 – Part numbers for chassis and bundles begin with
FI-SX-1600-
xxx...
•
FSX 1600 Acoustic Noise-Reduced (ANR) – An enhanced version of the FSX 1600 chassis, part numbers for
chassis and bundles begin with
FI-SX-1600-ANR-
xxx...
This section describes the similarities between these models. For details about how these models differ, see “FSX
1600-ANR Chassis” on page 2-9.
NOTE:
Except where explicitly noted throughout this manual, the FSX 1600 and FSX 1600-ANR chassis are
collectively referred to as the FSX 1600 chassis.
The FSX 1600 and FSX 1600-ANR chassis are 14 rack units in height and consist of the following:
•
Two half slots for the management modules
•
Two half slots for the switch fabric modules
•
Sixteen half slots for the interface modules
•
Eight slots for power supplies along the bottom of the card shelf.
S
lot 1
S
lot 2
F
a
n Tr
a
y
S
lot
3
S
lot 4
S
lot 5
S
lot 6
S
lot
8
S
lot 7
S
lot 10
E
S
D Connector
S
witch
F
ab
ric
S
lot 2
S
lot 9
S
witch
F
ab
ric
S
lot 1
AC OK DC OK
ALM
EJECT
S
Y
S
AC OK DC OK
ALM
EJECT
S
Y
S
AC OK DC OK
ALM
EJECT POE
AC OK DC OK
ALM
EJECT POE
F1
424C
F1
424C
F1
424C
F1
424C
F1
424C
F1
424C
F1
424C
F1
424C
Pwr
Active
Pwr
Con
s
ole
Ethernet
10/100/1000
Active
Pwr
Active
Pwr
Con
s
ole
Ethernet
10/100/1000
Active
