MR16 Supplementary manual
(for the MR16 without a CD-R/RW drive)
USB
USB HOST
MIDI OUT
DIGITAL OUT
FOOT SW
INPUT A SEL
GTR CLEAN
MIC/LINE
GTR DIST
Creating an audio CD using an external CD-R/RW drive
You can create an audio CD using an external CD-R/RW drive.
Connect an external CD-R/RW drive to the [USB HOST] port on the rear panel of the MR16
using a USB cable as show below (a USB cable is not supplied with the MR16).
USB cable
[USB HOST] port
USB 1.1 A type standard compatible
CD-R/RW drive
CD-R/RW disc
In the procedure described below, it is assumed that the following preparations are made.
• Both the MR16 and an external CD-R/RW drive are powered, while a CD-R/RW disc is set to the CD-
R/RW drive .
• The song which has the stereo WAV file to be burned is loaded.
9
About "Track at once" and "Disk at once"
The MR16 provides two burning modes for creating an audio CD in the CD-DA format.
"Track at once"
The unit burns a stereo WAV file to a CD-R/RW disc as a track. You can burn an additional
track at a later time until the disc is finalized. Each time you burn a file, a TOC is created.
Approximately two-second silence is automatically inserted between tracks.
"Disk at once"
The unit burns a stereo WAV file and automatically finalizes the disc. You cannot burn an
additional data. As described earlier in "2 MIX file playback mode", when one or more CUE
points are set to the stereo WAV file, file data is divided into tracks at the CUE points.
In this mode, no mute space is created between tracks. (Note that if the stereo WAV file does
not have any CUE point, it is burned as a single track.)
1)
Connect the MR16 to an external CD-R/RW drive
using a USB cable.
2)
While the MR16 is stopped, press the
[MENU/ENTER] knob to enter the MENU mode.
The display now shows the first page of the
menu selection screen.
3)
Use the [MENU/ENTER] knob to select
"USB HOST " on the second page and press
the [MENU/ENTER] knob.
The display now shows the USB HOST menu
screen.
