english
GB
Figure 7
Figure 8
Figure 9
Figure 10
Figure 11
Figure 17
Figure 18
Figure 12
Figure 13
Figure 14
Figure 15
3
Wall/Corner Panels
Prior to positioning and locking the corner and wall
panels together:
Apply two beads of mastic as shown (see fig 7) to
the female extrusion only.
Position and lock adjacent wall / corner panels using
the same locking procedure as described in
‘Panel Locks’ (Step 4).
Lock the wall panel to the floor panel securing them
in to place.
NOTE:
where access to external wall joints is not
possible after installation of coldroom, insert silicone
seal at the same time as mastic seals (see fig 7).
Do not silicone other joints at this time.
Refer to the Coldroom Assembly Detail for selec-
tion of the next wall panel and continue to erect
the rear wall, seal and lock into place until the
corner is reached (see fig12, 13 and 14).
With the sidewalls, rear and ceiling assembled
(see fig 18) seal all internal joints with silicone
sealer (see fig 19) taking care not to overfill.
Refer to the Coldroom Assembly Detail for selec-
tion of the next wall panel and continue to erect
the side wall, seal and lock into place but do not
fit the front corner (see fig15).
Ceiling Assembly
1.
Apply two beads of mastic as shown (see fig
16) to the wall panel top recess.
2.
Refer to the Coldroom Assembly Detail and
select a ceiling panel and place it in position.
3.
Select the next ceiling panel seal the edge with
mastic and lock it to the first panel.
4.
Continue until the whole ceiling is in position
(see fig 17 and 18) (on the smaller coldrooms
there will be two panels on larger coldrooms
more will be required).
STEP 7.
Figure 19
Figure 16
Front Left Hand Corner
Select the left-hand corner and adjacent wall panel
apply mastic to the edge of the female side of the
wall panel (see fig 7) and lock the corner to the panel.
Fit the white buttons into the corner/ wall lock holes
and apply a bead of silicon to the internal joint
between the wall and corner.
Apply mastic to the edge of the floor, female side of
the corner and the top of the 'L' shaped section also
(see fig 5 and 7).
Lift the corner/ wall panel and slot into place.
To lock the corner/ wall panel to the refrigeration
system panel it is necessary to open the door of the
refrigeration system panel (see fig 8). Remove the two
screws, one near the top of the door and one near
the bottom, from the opposite edge to the hinges
securing the door in the closed position. Remove the
white buttons from the holes adjacent to the lock
holes, Insert the hexagonal locking wrench into its
lock hole, making sure it is fully engaged, and lock
as described previously.
Fit the white buttons into the lock holes and refit the
white buttons in the holes in the door.
The mains lead for the coldroom is found behind the
refrigeration system door.
Pass the cable through the slot provided in the top of
the door ensuring that it does not get entangled in
any of the components.
Close the door and replace the screws ensuring they
are fully tightened.
With the refrigeration system panel and corner
locked firmly into place refer to the Coldroom
Assembly Detail for selection of the next wall
panel.
Select the next wall panel (see fig 9, 10 and 11),
and any subsequent side wall panel, seal and lock
into place until the rear corner is reached.
