Foster 7330240, User Manual

Page: 33 / 136

33
a d
c
b
WHAT TO DO IN CASE OF A PROBLEM
When the symbol [ E 4 ] appears:

The table must be reconfigured. Please implement the following steps :
I) Important : before you start, make sure there is no more pot on the hob
II) Disconnect the appliance from the grid by removing the fuse or turning the circuit
breaker off
III) Reconnect the table to the grid
IV) Procedure : take a pot with a ferromagnetic bottom and a minimum diameter of 16 cm
* start the procedure within 2 minutes after reconnecting the hob to the grid
* don’t use the [ O/I ] touch
V) First step : cancel the existing configuration
1) Press the touch n°2 and hold down
2) The symbol [ - ] will appear on each display
3) With your other hand, press successively
and quickly (less than 2s) on each [ - ] display.
Begin from the front right side and turn
contrary clockwise, as described on the
picture (from a to d).
A double "beep" means an error occured. If so, start again from item 1).
4) Remove your fingers from the touch control, then push again on touch 1 during
few seconds, until blinking [ E ] symbols appear.
5) Wait until [ E ] symbols stop blinking.
6) After few seconds, [ E ] are automatically transformed in [ C ]. The existing setup
has been cancelled.
Note :
For induction hobs with 3 cooking zones, as the right front zone doesn’t exist
in this case, begin the procedure with the right rear zone (b).
VI) Second step : new setup
1) Take a ferromagnetical pot with a minimum diameter of 16 cm
2) Select a cooking zone by pushing on the corresponding [ C ] display
3) Place the pot on the area to be set
4) Wait until the [ C ] display becomes a [ - ]. The selected cooking zone is now
configured.
5) Follow the same procedure for each cooking zone with a [ C ] display.
6) All the cooking zones are configured once all the displays are turned off.
Please use the same pot for the whole procedure.
Never put several pots together on the zones during the setup-process.

If [ E 4 ] displaying remains, please call the customer care
The hob or the cooking zone doesn’t start-up:

The hob is badly connected on the electrical network.

The protection fuse cut-off.

The looking function is activated.

The sensitive keys are covered of grease or water.

An object is put on a key.
The control panel displays [ U ]:

There is no pan on the cooking zone.

The pan is not compatible with induction.

The bottom diameter of the pan is too small.
The control panel displays [ C ] or [ E ]:

Call the After-sales Service.