16
IT
ELECTRICAL CONNECTION:
Before carrying out any connection, make sure the mains voltage
matches the one reported on the plate inside the appliance. We re-
commend asking a qualified technician to carry out the electrical con-
nection.
Appliance without a plug:
fit a plug in line with safety standards or an
omnipolar switch in line with safety standards with at least 3 mm
between open contacts. The earth cable must not be interrupted by
the switch.
We decline any responsibility for inconveniences deriving from failure to
follow these instructions.
The manufacturer reserves the right to make any changes without prior
notice.
CONTROL PANEL:
This is an electronic control panel and it is located at the front of the
hood.
KEY FUNCTIONS:
Lights
on/off.
0/1 Speed 1 on and motor off.
2
Speed 2 on.
3
Speed 3 on.
4
Speed 4 on.
NOTES:
- After 30 hours of hood operation, the LEDs for “keys 1, 2, 3, 4”
flash for 30 seconds with the motor off to report that the filters need
to be changed.
PLEASE NOTE: the alarm is RESET by pressing the “speed 3” key
and holding it for a “prolonged period of time”.
- The edges of the keys are always lit. Press the “speed 1” key with
the motor off and hold it down for a “prolonged period of time”.
PLEASE NOTE: to turn the lights back on, press the “speed 1” key
again and hold it down for a “prolonged period of time”.
- The motor’s switch-off can be automatically delayed by pressing one
of the speed keys and holding it for a “prolonged period of time”.
The motor will remain on for 10 minutes.
Fig. 8
4
3
2
0/1
EN
