Problem Solution
Outdoor sensor
communicate to
the display
console.
The sensor array may have initiated properly and
by the console as invalid, and
the console must be reset. Press the reset button
as described in Section 5.2.
With an open ended paperclip, press the reset button
for 3 seconds to completely discharge the voltage.
Take out the batteries and wait one minute, while
covering the solar panel to drain the voltage.
Put batteries back in and resync the console with the
sensor array about 10 feet away.
The LED next to the battery compartment will flash
every 16 seconds. If the LED is not flashing every
16 seconds…
Replace the batteries in the outside sensor array.
If the batteries were recently replaced, check the
polarity. If the sensor is flashing every 16 seconds,
ference or other
location factors,
or the batteries may have been changed in the
sensor array and the console has not been reset.
The solution may be as simple as
powering down
and up the console
(remove AC power and
batteries, wait 10 seconds, and reinsert AC power
and batteries).
array does not
the data is registered
proceed to the next step.
There may be a temporary loss of communication
due to reception loss related to inter
Temperature
sensor reads too
high in the day
time.
Make certain that the sensor array is not too close to
heat generating sources or strictures, such as
buildings, pavement, walls or air conditioning units.
55
