5
Up to
16 DMX Universes
can be transmitted simultaneously using multipoint to multipoint operation. All
receivers in a multipoint system will listen only to the designated transmitter without any delays or
interference from other systems working alongside.
Adding Receivers
1.
Power on the Receiver unit(s) and ensure that they are not linked with any other transmitter (LINK
indicators should be OFF).
2.
Press and quickly release FUNCTION button on the Transmitter. The transmitter will scan for all
unlinked receivers for a period of 10 seconds - the LINK indicator on both the Transmitter and
Receiver(s) will flash rapidly.
3.
If successful, the LINK indicator on Receiver(s) now go ON. If any failed, check that the Receiver is
in range and repeat procedure.
You can add receivers at any time, even during operation. In an operational system, logging
on an additional receiver will make the logged-in units revert to idle mode for 10 seconds;
once the new units are logged-in they will all start again together with the new unit.
Unlink a Receiver
Press and hold the
FUNCTION
button on the Receiver for about 3 seconds till the
LINK
indicator go off.
Now the Receiver is unlinked.
Unlink all Receivers
On the Transmitter, press and hold the
FUNCTION
button until
LINK
begins flashing. All registered
Receivers linked to that Transmitter will be unlinked.
The Receiver will stay linked/logged on to the Transmitter no matter DMX signal or power is
cut off. The log-in information is stored in an EEPROM and will not be erased.
Setting a TRANSCEIVER to Transmit or Receive
Summary of Contents for WDMX TRX
Page 1: ...1 FOS WDMX TRX...
