280W BEAM SPOT WASH 3-IN-1 MOVING HEAD
Page 6
3.
Operation and parameter instruction
Via following operation, enter sub menu(parameter menu) shown in Figure 6
In main menu, click 1/6 function button into corresponding parameter menu.
In sub menu(page), click main item on the left side of displayer, can shift to corresponding
sub menu(page) quickly.
1.
Set DMX Address
Click and select the "ADDR", can enter the page of DMX address setting, range from 1 to 512, the
address code shouldn’t is not greater than (512- channels quantity), otherwise the light will not
been controlled. Following is the operation:
Enter the page of DMX address, as shown in Figure 7, click the blank area in right side of display
will pop-up diglog as in Fig. 4, modify value, then click ‘ENTER’ to confirm and save DMX
address code.
Figure 7 page of DMX Address
2. Set Light work mode
Enter the page of ‘WORK MOD’ as shown in Figure 8 and modify setting. Can set light work
mode, control lamp and DMX channel mode..
Light includes 3 work mode: DMX MODE, AUTO RUN and SOUND MODE, Parameter
definition as following:
DMX Mode
：
Under this mode, the light receive data from the DMX controller and move.
AUTO RUN
：
Under this mode, light will run with inside code(data), ignore data from DMX
controller.
SOUND Ctrl
：
Under this mode, light ignore data from DMX controller., When there is a
strong sound in stage, the light will run a scene, otherwise it will keep the last scene.
M/S Choose
：
’M/S Choose’ is available when light just in ‘AUTO RUN’ or ‘SOUND Ctrl’
mode. If this item is set as ‘OFF’, the light don’t send data to other light via DMX Cable.
When ‘ON’, the data will send to other slave light immediately.
Lamp control
：
Turn on lamp when this item is set ‘ON’, otherwise, turn off lamp. The gap
between operation is limited to 30 second.
Channel mode
：
Light support 2 DMX Channel mode: sample or extend
。