Installa
tion
3
Installatio
1
2
3
4
jacket nut
sensor
protective cap
flat washer
rubber washer
5
6
Transmitter installation steps:
remove tires from the car, remove the rubber tire after the tires
were deflated
clean the rim
Screw the protective cap, jacket nut, flat washer from the
transmitter to be installed.
Insert sensor into the corresponding location of the tire valve,
and then be fixed by jacket nut.
Pay attention to avoid the location of transmitters when install
rubber tire. After inflation of the tires according to the tire
inflation pressure value , screw protective cap to complete the
installation.
In accordance with the above steps to install other transmitters.
[
]
Transmitter should be installed by professionals. The steps must be in
accordance with Stickers shown on the transmitter to ensure that the
installation is correct and reliable.
:
Note
①
②
As the transmitters install on the valve mouth, extrusion on the rubber
valve should be avoid to prevent leakage or damage.
③
After transmitter installation, you must do the tire dynamic balance test,
otherwise normal driving will be affected.The product only applies to
vacuum tire installation.
Summary of Contents for TPMAI1DIC1
Page 1: ...TPMS USER MANUAL TPMS USER MANUAL...
Page 2: ......