EN
22
on the screen whenever any button
is pressed while the machine is child-
locked.
To deactivate the child-proof lock,
press the 2nd and 4th auxiliary function
buttons for 3 sec.
“COFF ” (Child lock is deactivated) label
appears on the screen.
Ending the program through
cancelling
“Start/Pause/Cancel” button (Figure 2-
10) is pressed for 3 seconds to cancel
the program. Start symbol (Figure
3-13j) will flash during cancellation.
After cancellation, the symbol of the
corresponding step at which the
cancellation was made will remain lit and
“End” label will appear on the screen.
Program in rinse hold mode
This process is shown with the
flashing Spin Symbol (Figure 3-
13c) and the lit up Standby Symbol
(Figure 3-13k).
If you wish to spin when the machine is
in this mode:
Adjust the spin speed. Press “Start/
Pause/Cancel” button (Figure 2-10).
The program continues, pumps out
the water and spins.
s
The
the
tandby symbol
(Figure 3-13k) fades out and
start
symbol (Figure 3-13j) lights up.
If you want to discharge the water only and
without spinning:
Press “Start/Pause/Cancel” button
(Figure 2-10).
s
The tandby symbol
(Figure
3-13k) will fade.
s
The tart symbol
(Figure 3-13j) will light up. The program
continues and only pumps out the water.
End of program
When the program is finished, the
symbols of the relevant steps will remain
lit up and the auxiliary function, spin and
temperature data selected at the start-
up of the program will remain selected.
“End” label will appear on the screen.
Your machine is equipped with
a “Standby Mode”
In case of not starting any programme or
waiting without making any other operation
when the performed approximately 2 minutes
after the programme you selected has come
to an end, your machine will automatically
switch to energy saving mode. Display
brightness will decrease. In case of rotating
the Programme Selection knob or pressing
any button, lights will restore to their previous
condition. This is not a fault.
