Fortress Technologies ecure Wireless Access Bridge, User Manual

Page: 109 / 144

Fortress Bridge: Command-Line Interface
99
6.4.9.2 Internal LAN Switch Port 802.1X Settings
You can individually configure each of the ports of the Bridge’s
internal LAN switch to require that a connected device is an
802.1X supplicant successfully authenticated by the 802.1X
authentication server configured for the Bridge (Section 6.4.9).
View current LAN port settings with the
show
command:
[GW]>
show 8021X
Lan1:off
Lan2:off
Lan3:off
Lan4:off
Lan5:off
Lan6:off
Lan7:off
Lan8:off
AuthServer:127.0.0.1
AuthPort:1812
The
Lan
numbers shown correspond to the Bridge’s front-panel
switch port labeling. By default, the 802.1X authentication
requirement is turned
off
for all eight ports.
Use the
set
command with just the
8021X
argument to
configure the 802.1X server interactively. The Bridge CLI
presents one field at a time, and you can either backspace over
the existing value for a given field and enter a new value or
strike
Enter
↵
to leave the value unchanged and go on to the
next field.
Alternatively, you can use the
set 8021X
command with valid
arguments to change 802.1X LAN port settings:
[GW]>
set 8021X [lan1|2|3|4|5|6|7|8] [on|off]
Changing LAN port settings requires you to reboot the Bridge
to effect your changes.
The
show 8021X
and
set 8021X
commands are valid only in
GW (gateway) mode (refer to Section 6.1.1 for more detail).
6.5 Administration in the Bridge CLI
6.5.1 Trusted Devices in the CLI
View configured Trusted Devices with
show td
:
[GW]> show td
NAME IP MAC PORT
guests 123.45.6.7 11:22:33:44:55:66 80
audit 123.67.8.9 33:44:55:66:77:88 80,443
print1 234.56.7.8 22:33:44:55:66:77 23
Total TD: 3
Use the
add
and
del
(delete) commands to manage Trusted
Devices for the Bridge-secured WLAN, as described in the
following sections.