Setup the FortiSwitch-80-PoE using the following steps:
•
The surface must support at least 1.5 Kg for the switch.
•
The power outlet should be within 1.82 meters (6 feet) of the switch.
•
Visually inspect the DC power jack and make sure that it is fully secured to the power adapter.
•
Make sure there is adequate ventilation around the switch for proper heat dissipation.
•
Do not place heavy objects on the switch.
Step 2. Installing
© Copyright 2010 Fortinet Incorporated. All rights reserved.
Products mentioned in this document are trademarks or registered trademarks
of their respective holders.
05 November 2010
11-100-0133349-20101112
Step 3. Connecting
Step 4. Powering on
Connect the switch to the power outlet and then turn the power switch on to activate the switch. The power switch is located at the back of the unit.
The FS-80-PoE can supply power to a PoE capable device over an existing Ethernet cable. If a device is not compatible, or does not operate on
PoE, then the port will not source power to this device. This feature allows users to freely and safely mix legacy and Power over LAN compatible
devices on their network.
The FS-80-PoE supports 8 10/100/1000M Ethernet ports. Ports 1 – 4 supply PoE automatically when connected to a 802.3af compatible device.
Ports 5 – 8 do not provide PoE, and are best suited for uplink ports, PCs and printers. These ports automatically detect and operate in half and full
duplex mode.
The FS-80-PoE provides auto MDI-II or MDI-X cable selection for easy connection using standard or crossover RJ45 cables.
Note
: It is important that the PoE is used indoors only. Ensure that Ethernet cable carrying PoE power does not route outside of the building.
Ports 1 - 4 4 × 10/100/1000 Mbps Auto-MDIX RJ45 ports with
POE enabled
Port 5 - 8
4 × 10/100/1000 Mbps Auto-MDIX RJ45 ports
