Fortinet FortiMail-100, Install Manual

Page: 55 / 174

FortiMail-5001A hardware installation FortiMail mounting components
FortiMail™ Secure Messaging PlatformVersion 4.0 Patch 1Install Guide
Revision 2
55
http://docs.fortinet.com/ • Feedback
• An electrostatic discharge (ESD) preventive wrist strap with connection cord
1 Attach the ESD wrist strap to your wrist and to an available ESD socket or wrist strap
terminal.
2 If you have installed the FortiMail board in a chassis, remove it.
For removal instructions, see
“Removing a FortiMail board” on page 59 .
3 Use Figure 22 to locate SW11 on the FortiMail board.
The top of the FortiMail board is covered with a copper heat sink. The printed circuit
board is under the copper heat sink. SW11 is located on the printed circuit board and is
accessible from the left side of the FortiMail board under the copper heat sink (see
Figure 22 ).
Figure 22: Location of SW11 on the FortiMail board
4 If required, change SW11 to the correct setting.
5 Insert the FortiMail board into a chassis and verify that the board starts up and
operates correctly.
For inserting instructions, see
“Inserting a FortiMail board” on page 56 .
FortiMail mounting components
To install a FortiMail board you slide the board into an open slot in the front of an ATCA
chassis and then use the mounting components to lock the board into place in the slot.
When locked into place and positioned correctly the board front panel is flush with the
chassis front panel. The board is also connected to the chassis backplane.
Caution: FortiMail boards must be protected from static discharge and physical shock.
Only handle or work with FortiMail boards at a static-free workstation. Always wear a
grounded electrostatic discharge (ESD) preventive wrist strap when handling FortiMail
boards.
FortiManager-5001A
Front Faceplate
Location of SW 11
Factory Default (Shelf Manager Required)
ON
SW11
3 4 2 1
1 Off
2 On
3 Off
4 Off
ON
SW11
3 4 2 1
1 Off
2 On
3 On
4 Off
Standalone Mode for FortiGate-5020
(no Shelf Manager)
FortiManager-5001A
board (top view)