Page 5
To mount your camera
1.
Using the security Torx key,
loosen the 4 security screws
on the housing. The screws will
not come out completely, but
enough to detach the base.
2.
Remove the dome cover.
3.
Using the template as a
guide, pre-drill pilot holes in the
wall/ceiling, then hammer the
plastic anchors into the holes.
(If possible, for more secure
mounting, omit the anchors;
instead, pre-drill holes into a
framing stud.)
4.
If your network cables are inside the wall/ceiling, drill a hole large
enough to pass the camera’s cable through the wall/ceiling. Thread the
camera’s PoE cable though the hole. (If using the optional mounting
base, thread the PoE cable through the base, then through the hole
in the wall.)
5.
Plug the your network cable into the camera’s PoE connector.
6.
Hold the camera to the wall/ceiling, aligning its mounting holes with the
holes in the wall/ceiling.
7.
Insert the 3 screws through each elongated hole in the camera base
(and, optionally, mounting base), then twist the screws into the wall
anchors or stud. Tighten the screws with a screwdriver until the
camera base is firmly in place. If using the mounting base, use the
longer screws, not the shorter ones.
