Cautions and Warnings
Environmental specifications
Ambient operating temperature: 0C to 60C
Refer to specific Product Model Data Sheet for Environmental
Specifications (Operating Temperature, Storage Temperature,
Humidity, and Altitude)
Référez à la Fiche Technique de ce produit pour les caractéristiques
environnementales (Température de fonctionnement, température
de stockage, humidité et l’altitude).
Safety
Warning: Equipment intended for installation in Restricted Access
Location.
Avertissement: Le matériel est conçu pour être installé dans un
endroit où l’accès est restreint.
Caution: This equipment is to be used in a Network Environment 0
per IECTR 62101. This product is connected only to PoE networks
without routing to the outside plant.
Attention: Ce matériel doit être utilisé dans un Environnement
Réseau 0 par IECTR 62101. Ce produit est uniquement connecté aux
réseaux PoE sans installation externe de routage.
FAP-U432F is intended to be supplied by a Listed Direct Plug-In
Power Unit marked LPS or Class 2 and rated 54 Vdc, 1.11A from
PoE source.
Le FAP-U432F est conçu pour être alimenté par un bloc d’alimenta-
tion enfichable direct répertorié marqué LPS ou Classe 2 et évalué à
54 Vcc, 1,11 A à partir de la source PoE.
FAP-U234F is intended to be supplied by a Listed Direct Plug-In
Power Unit marked LPS or Class 2 and rated 54 Vdc, 0.6A from
PoE source.
Le FAP-U234F est conçu pour être alimenté par un bloc d’alimenta-
tion enfichable direct répertorié marqué LPS ou Classe 2 et évalué à
54 Vcc, 0,6 A à partir de la source PoE.
Grounding — To prevent damage to your equipment, connections
that enter from outside the building should pass through a
lightning/surge protector, and be properly grounded. Use an
electrostatic discharge workstation (ESD) and/or wear anti-static
wrist strap while you work. In addition to the grounding terminal
of the plug, on the back panel, there is another, separate terminal
for earthing.
Mise à la terre — Pour éviter d’endommager votre équipement, les
connexions qui entrent de l’extérieur du bâtiment doivent passer
par un parafoudre / surtension et être correctement mises à la terre.
Utilisez une station de travail à décharge électrostatique (ESD) et /
ou portez un bracelet antistatique pendant que vous travaillez. En
plus de la borne de mise à la terre de la fiche, sur le panneau arrière,
il y a une autre borne séparée pour la mise à la terre.
Regulatory Notices
Federal Communication Commission (FCC) – USA
This device complies with Part 15 of FCC Rules. Operation is subject
to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received; including
interference that may cause undesired operation.
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in residential installation. This
equipment generates, uses, and can radiate radio frequency energy,
and if it is not installed and used in accordance with the instruction
manual, it may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation.
If this equipment does cause harmful interference to radio or televi-
sion reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference
by one or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and
receiver.
•
Connect the equipment into an outlet on a circuit differ-
ent from that to which the receiver is connected.
•
Consult the dealer or an experienced radio/TV technician
for help.
WARNING: Any changes or modifications to this unit not expressly
approved by the party responsible for compliance could void the
user’s authority to operate the equipment
For model FAP-U234F
This equipment complies with FCC radiation exposure limits set
forth for an uncontrolled environment. This equipment should be
installed and operated with minimum distance 36cm between the
radiator and your body. This transmitter must not be co-located or
operating in conjunction with any other antenna or transmitter.
For model FAP-U432F
This equipment complies with FCC radiation exposure limits set
forth for an uncontrolled environment. This equipment should be
installed and operated with minimum distance 30cm between the
radiator and your body. This transmitter must not be co-located or
operating in conjunction with any other antenna or transmitter.
This device meets all the other requirements specified in Part 15E,
Section 15.407 of the FCC Rules.
Industry Canada Equipment Standard for
Digital Equipment (ICES) – Canada
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe B est conforme à la norme
NMB-003 du Canada.
