VALET MODE (BY DEFAULT)
With EVO-ONE ONLY
. To activate and deactivate Valet Mode using the antenna proceed with the fol-
lowing steps :
STEP 1
Insert the key and turn it to the ignition (ON/RUN) position. The
vehicle does not need to be started.
STEP 2
X3
Within 10 seconds press and release the button on the antenna
3 times.
STEP 3
Valet mode enabled : The LED is ON
Valet mode disabled : The LED is OFF
VALET MODE (VIA REMOTE)
Valet Mode disables the remote-starter and alarm. Whenever the vehicle is being serviced or
repaired, or the vehicle is parked indoors it is mandatory that Valet Mode be enabled to prevent an
accidental Remote-Start.
Note :
The alarm system is deactivated (including Starter Kill) when the system is in Valet Mode.
However you are still able to lock & unlock the doors, and release the rear hatch/trunk. This method
of enabling/disabling Valet Mode uses the remote transmitter instead of the valet switch indicated
in the preceding section.
To enter Valet Mode using the remote transmitter proceed with the following steps :
STEP 1
+
Press and release the FUNCTION button, within 12 sec-
onds simultaneously press and hold the LOCK and UN-
LOCK buttons for 1 second.
The parking lights will flash once (The function must be
programmed by the installer).
STEP 2
The LED will turn ON solid and remain ON.
To exit Valet Mode using the remote transmitter proceed with the following steps :
STEP 1
+
Press and release the FUNCTION button, within 12 sec-
onds simultaneously press and hold the LOCK and UN-
LOCK buttons for 1 second.
The parking lights will flash once (The function must be
programmed by the installer).
STEP 2
The LED will turn OFF or will start to flash.
Page 16 / 23
Summary of Contents for 12084A-DL1004
Page 2: ...TABLE OF CONTENTS ...
