FortiGate Voice, Administration Manual

Page: 45 / 50

FortiGate Voice VoIP, PBX, and PSTN CLI Reference config system interface
FortiGate Voice Version 4.0 Administration Guide
01-400-112851-20100127
45
http://docs.fortinet.com/ • Feedback
set hangup-on-polarity-reversal
set hangup-on-zero-voltage
set hangup-on-busy-tone
set busycount <integer>
set busy-tone-length <integer>
set busy-quiet-length <integer>
set codec {alaw | ulaw}
end
config system interface
Use this command to allow traffic for the VoIP protocol, SIP, to flow on a specific interface.
Syntax
config system interface
edit <interface_name>
set voip {enable | disable}
Variables Description Default
edit <fxo_name>
Enter the name of the FXO. No
default
cid-name
<caller_name>
Enter the caller ID name that will appear on the LCD panel
as caller ID on the phone.
No
default
echo-cancel
{enable | disable}
Enable to support echo-cancelling for the port. No
default
status
{enable | disable}
Enable the status of the port. No
default
user-callerid
{enable | disable}
Enable to catch the caller ID. No
default
cid-signalling {bell
| dtmf | v23 | v23-
jp}
Enter the caller ID protocol. The protocol v23-jp is the v23
protocol for Japan.
No
default
cid-start
{polarity | ring}
Enter to start transmitting the caller ID. No
default
send-callerid-after
<integer>
Enter a number for the number of rings after that the caller
ID began to transmit.
No
default
hangup-on-polarity-
reversal
Enter to have the phone hang up when there is polarity
reversal.
No
default
hangup-on-zero-
voltage
Enter to have the phone hang up when there is zero
voltage.
No
default
hangup-on-busy-tone
Enter to have the phone hang up when a busy tone is
detected.
No
default
busycount <integer>
Enter a number for the accurate number of busy tones that
are detected.
No
default
busy-tone-length
<integer>
Enter a number that determines how logn the busy tone is
on.
No
default
busy-quiet-length
<integer>
Enter a number that determines how long the busy tone is
off.
No
default
codec {alaw | ulaw}
Enter the Codec preference type based on the country. No
default