Test
Button
Ant
work
Jumpers
Tamper switch
Infrared sensor
AA 1.5V LR6
enna
LED
ing indicator
T
elephone : 01527 51 51 50
Fax: 01527 51 51 43
Email : [email protected]
Web : www.espuk.com
E&OE - Errors and omissions excepted.G21
Guidance
>Smart alarm accessories are specified at a maximum of 80 meters Line of Sight (LoS) in
open air. For every obstacle the signal strength is reduced.
> Battery life depends on working and environmental factors.
For more product information please visit the ESP website
For pairing instructions, please refer to the main Hub Manual.
Elite Security Products
Redditch B98 8YN
Mode Setting
Testing Mode
Once the self-testing is complete, long press the test button. The sensor switches to testing mode,
and scans once every 10 seconds. After 3 minutes, the LED blinks twice, and the sensor switches
to working mode.
Working mode / Stand-by mode
In working mode, if the sensor is triggered more than twice within 3 minutes,
it will switch to standy mode to save power. If no movement is detected within
the next 3 minutes, the sensor will switch to working mode.
Register the detector in the alarm system
Switch to connection mode on the control panel. Press the test button of the
sensor twice. The control panel beeps once; the motion detector is registered.
If you hear two beeps, the detector has already been connected.
To check if the registration is complete, arm the system and trigger the sensor again. If the siren rings
out, the registration is successful.
LED Indication
Flashes Continuously: Self-Testing
Flashes Once: An intruder is detected
Flashes Twice: Self-testing is complete; entering
operating mode
Flashes 3 times every 3 second: Under-voltage
indications, the batteries must be replaced
(the user will be informed that the batteries
are low).
PCB Layout
Infrared Sensor: Detects the infrared rays released by human body motion.
Do not touch the surface, keep the surface clean.
Tamper Switch: When the alarm system is armed, the tamper switch will
trigger the alarm if the case is opened.
Jumper setup: Function Reserved