Förster-Technik TAP5-CH2-25, Original Operating Instructions

Page: 65 / 131

Running the automatic feeder 65
10. Insert the mains plug again and turn on the automatic feeder again using the control
switch.
11. Press until the message Start automatic mode? appears in your display.
12. Confirm Start automatic mode? by choosing .
The automatic feeder is now operating in automatic mode again.
6.4.3.3 Circuit cleaning
With circuit cleaning, you simultaneously clean the suction hoses
Use the mounting holders provided for this procedure.
1 2 3 4
6
5
1 Hose nozzle 4 Suction hose (first station)
2 Cleaning adaptor 5 Suction hose (second station)
3 Rubber closing cap 6 Coupling for milk supply
Run circuit cleaning at least once a day if automatic mixer cleaning is not enabled.
Run circuit cleaning at least once a week if automatic mixer cleaning is enabled.
You set circuit cleaning as follows:
1. Choose > Cleaning to go to the Circuit cleaning submenu.
2. In Water/station , you enter the desired amount of water. You can enter values from 0.5 l to
1.5 l. The preset default value is 1 l.
Note: The longer the hoses, the higher the value you must select.
3. Confirm start? by choosing .
The message Exit automatic mode? appears in the display.