Forno Venetzia TORINO 300, Assembly Manual

Page: 10 / 32

8
19. With assistance, position the oven body
on top of the cart with the oven mouth at
the front of the cart. The sliding shelf will
be on the right side of the oven.
Ensure the corners of the oven are exactly
lined up with the corners of the cart. This
aligns the screw holes in the cart with the
threaded screw holes in the bottom of the
oven that attach the oven to the cart.
20. From underneath the sliding shelf
housing, attach the oven to the cart using
the hexagon socket screws provided as
illustrated.
Ensure all 4 screws are completely inserted
and tightened to firmly secure the oven
body to the cart.
21. Attach the adjustable tool holder using
4 plastic head screws and 4 plastic
washers.
19. With assistance, position the oven body
on top of the cart with the oven mouth at
the front of the cart. The sliding shelf will
be on the right side of the oven.
Ensure the corners of the oven are exactly
lined up with the corners of the cart. This
aligns the screw holes in the cart with the
threaded screw holes in the bottom of the
oven that attach the oven to the cart.
20. From underneath the sliding shelf
housing, attach the oven to the cart using
the hexagon socket screws provided as
illustrated.
Ensure all 4 screws are completely inserted
and tightened to firmly secure the oven
body to the cart.
21. Attach the adjustable tool holder using
4 plastic head screws and 4 plastic
washers.
Position the plastic washers behind the
tool holder to prevent the tool holder from
scratching the leg panel as illustrated.
22. To extend the retractable tool holder slide the tool holder upward until the plastic head
screws can be steered into the “hooks” on the left side of the slot in the tool holder.
23. Ensure all 4 plastic head screws are completely inserted into the “hooks” and the tighten.
This helps minimizes the possibility of the tool holder retracting when holding oven tools in the
extended position.
Position the plastic washers behind the
tool holder to prevent the tool holder from
scratching the leg panel as illustrated.
22. To extend the retractable tool holder slide the tool holder upward until the plastic head
screws can be steered into the “hooks” on the left side of the slot in the tool holder.
23. Ensure all 4 plastic head screws are completely inserted into the “hooks” and the tighten.
This helps minimizes the possibility of the tool holder retracting when holding oven tools in the
extended position.
24. To retract the tool holder, remove all tools, and loosen all 4 plastic head screws. Now lift the
tool holder slightly to take it off the “hooks” and gently allow it to slide down in to the storage
position.
25. Slide the chimney pipe into the flue opening on the top of the oven. Ensure it is completely
in place and straight.
26. Slide the chimney cap into the top of the chimney pipe. Ensure it is also completely inserted
into the chimney pipe.