- 19 -
7.1.3 TROUBLESHOOTING
THE OVEN DOES NOT COOK EVENLY
* The products to cook have been pressed too close to each other.
You should always check there is good air circulation between the products.
YOUR PRODUCT IS DRY AND IS UNFIT FOR CONSUMPTION
* Check whether the humidifier is working and whether the temperature is the right one for your product.
7.2
MAINTENANCE
Before doing any maintenance work you must cut off the electricity and water supplies to the oven.
All the oven components, being subject to wear, are easy to reach from the right-hand side.
7.2.1 REPLACING COMPONENTS
CAUTION: Have this done by a skilled technician only!
Disconnect the electricity and water supplies.
Follow the wiring diagram.
A) Electric components and electronic card
All the electric components and the electronic card are on the right-hand side of the oven.
In order to replace them, you therefore need to take off the right-hand side panel.
This is why the oven should be installed with sufficient clearance on the right-hand side.
B) Resistor
To replace the resistor:
- Remove the rear panel.
- Open the screen inside the oven.
- Detach all the wires.
- Remove the resistors.
- Fit it all back together in reverse order to the above
and using the wiring diagram.
C) Oven lamp Tab.3
- Remove both screws (1).
- Remove the frame (2) with glass (3).
N.B. Check that the silicone rubber gasket is not damaged.
- Replace the oven lamp (4).
- Fit it all back together in reverse order to the above.
7.1.2 DESCALING THE BOILER
Every 7 - 15 days it is advisable to carry out descaling.
- Drain the boiler by pressing the
button then close it again.
- Prepare a solution of descaling liquid following
the manufacturer’s directions.
Quantity of diluted solution:
FEM67 = 4 l
FEM107 = 5.5 l
FEM207 = 5.5 l
- Lift the cap 1 (Tab.7) and pour the solution into the boiler.
- Operate the oven with the steam function for approximately
2-3 minutes to pre-heat the solution.
- Let the liquid act approximately 10' then drain the generator.
- Switch the control panel off and back on again by turning the
selector so as to load the boiler. When loaded, drain it again.
N.B. For the steam generator to function properly
the water softener requires thorough maintenance
in order to avoid scale.
TAB. 7
