Play audio through a channel at the required level and trigger the priority using the “LOCAL TEST” switch. Through
the back panel using a small flat blade screwdriver adjust the priority programme attenuation potentiometer marked
“ATTEN” (generally music should be quiet but audible).
Play audio through the priority input and through the back panel using a small flat blade screwdriver adjust the
priority level potentiometer marked “LEVEL” for the maximum required system level, individual channel levels can
then be adjusted below this level if required.
Play audio through channels 1
– 10 and through the front panel using a small flat blade screwdriver adjust the
potentiometers marked 1
– 10 fully for the required priority level on any channels where it is required to be lower
than the system level
.
Mains Voltage
The CX10 has been designed to operate on 220-240Vac, a 110-120Vac version is available on request from
Formula Sound.
Fuses
Mains fuse sizes are 250mA anti surge for 220-240V operation and 500mA anti surge for 110-120V operation.
It is
important for safety reasons that the correct fuse sizes are always used.
Internal
There is a ground/Earth lift located by the mains transformer towards the back and side of the unit. Removing this
may be necessary in some installations. A skilled audio system specialist should determine if this is necessary,
otherwise this should be left in the factory supplied or normal position.
N.B. Internal settings should be undertaken by skilled personnel only
.
DISCONNECT THE UNIT FROM THE MAINS SUPPLY
Remove the top case cover by removing 6 screws located at the sides of the unit and 2 screws located on the top of
the unit. (Re-assemble in the reverse order)
DAMAGE MAY RESULT IF THE UNIT IS CONNECTED TO THE WRONG SUPPLY VOLTAGE
THIS UNIT MUST BE EARTHED
Page 2
Lime Technologies
http://limetechnologies.co.uk
Tel: 08712 233127
