Maintenance manual | Electro-pneumatic sliding dampers
www.formula-air.com
9
Step 6 : Repeat steps 1 to 5 if the sliding damper is equipped with two cylinders.
3.2.2 For sliding dampers with SQUARE cylinders
Step 1 : Screw the cylinder support to the base of the cylinder with the washers and bolts.
Step 2 : Insert the head of the cylinder through the hole in the top of the sliding damper body.
Step 3 :
Screw the head of the cylinder body to the sliding damper body with washers and bolts.
Step 4 : Secure the cylinder support to the damper body using bolts, washers and nuts.
Step 5 : Pull the sliding damper blade completely out (make sure that the hole in the middle of the blade is
aligned with the pipe pieces of the sliding damper body).
Step 6 : Pull out the cylinder rod, pass it through the hole at the top of the sliding damper blade, and tighten
the two counter-nuts using a bit of Loctite.
Step 7 : Repeat steps 1 to 6 if the sliding damper is equipped with two cylinders.
Bolt
Washer
Bolt
Nut
Washer
Bolt
Washer
Nut
Counter-nut
