CROSS TABLE
SURFACE MOUNT INSTALLATION INSTRUCTIONS
page 1 of 2 | Rev. 12-18-12
© 2012 Forms+Surfaces® | All dimensions are nominal. Specifications and pricing subject to change without notice. For the most current version of this document, please refer to our website at www.forms-surfaces.com.
T 800.451.0410 | www.forms-surfaces.com
TOOLS NEEDED
MATERIALS INCLUDED
STEP BY STEP
Attach table top to column
• Use drill with 1/2" nut driver (or socket
wrench with 1/2" socket) to attach table
top to column with 5/16"-18 x 3/4"
hex head bolts (a).
Mark hole locations
• Place table in desired location. Mark
center of each hole location with a pencil.
Drill holes
• Use hammer drill to drill 1-7/8" deep x
1/2" diameter anchor hole at each
marked location using a 1/2" drill bit
suitable for concrete drilling.
NOTE: Forms+Surfaces recommends
starting holes with 3/16" diameter drill
bit followed by 3/8" and finally 1/2" for
maximum accuracy.
a
b
c
d
FOR ALL SURFACE MOUNTED CROSS TABLES
steel
wire brush
hammer drill
pencil
hammer
1/4
"
punch
1/2
"
nut driver
a
7/32
"
hex bit for
tamper-resistant
screws
e
f
3/16
"
, 3/8
"
& 1/2
"
drill
bits for concrete
