Set-up Guidelines
1. Install the shredder on a level surface, away from heat sources and direct sunlight.
2. Insert plug into wall outlet with the appropriate voltage.
Specifications
Operation
1. Open the breaker panel door (lower
left side of shredder case). Flip ON the
breaker. Close door.
2. Insert key and turn Power switch to ON.
3. Slide open the appropriate shredding
chamber door (left for larger desktop
drives, right for smaller laptop drives).
4. Drop in one drive at a time (Fig. 1 or 2)
5. Slide shut the safety cover.
6. Press START on the control panel. The
shredding shredding will begin.
Wait until the shredding chamber is
clear before pressing STOP.
WARNING:
DO NOT attempt to open
the shredding chamber door during
shredding. The motor and blades will
automatically stop turning, but particles
may fly out before they have stopped.
If you need to stop the shredder before
the chamber is clear, press the red
Emergency Stop button.
7. Each shredding chamber has a
separate LED counter (Fig. 3). To reset
a counter, press the RESET button.
8. When shredding job is complete, press
the STOP button on the control panel,
and turn the key lock left to the OFF
position.
* Capacity may vary due to variations in power supply.
Control Panel
Reverse Operation
Push the REV button and the “REV” LED will light and
cutters will operate in reverse. This will help to clear a
jammed drive.
Waste Bin Full Sensor
If the waste bin is full, the “FULL” LED will light and the
shredder will stop automatically. Open the waste bin
door, remove and empty the waste bin (Fig. 4). Replace
the waste bin, close door, and press START to resume
shredding.
Fig. 1 Desktop drive infeed
Fig. 2 Laptop drive infeed
Waste Bin Full LED
Cleaning Mode LED
Door Open LED
Emergency Stop Button
Reverse Button
Start Button
Stop Button
ON / OFF Key Lock
3.5” Desktop Hard Drive
2.5” Laptop Hard Drive
Feed Opening:
4.72” (120mm)
3.54” (90mm)
Shred Particle Size: 1.6” (40mm) x random
.19” (5mm) x random
Infeed Capacity:
1 hard drive at a time
1 hard drive at a time
Speed:
3 - 4 drives per minute
3 - 4 drives per minute
Dimensions:
19.68” W x 18.5” D x 35” H (500 x 470 x 890mm)
Weight:
1,102 lbs. (500kg)
Security Level:
H-6 (DIN 66399 standard)
Power Supply:
220V 20Amp 3 Phase
NEMA Plug / Receptacle L1520P / L1520R
The control panel LEDs will light to indicate the shredder’s status.
Fig. 4
Fig. 3
