Operation
1. Open the door and fl ip the breaker switch to the“ON” position.
Close door. Press the Power Switch on the right side of the
shredder to the “ON” position (This switch should be used to
turn the power on an off).
2.
Auto Start/Auto Stop
When the “START A/M” button is pushed, the signal lamp
“AUTO” will light. Insert paper to shred. The shredder will start
and stop automatically when using this function.
3.
Manual Operation
If paper is too small for the shredder’s sensors to detect, shred
it manually. Push the “START A/M” button once more and the
“MANUAL” lamp will light. Insert paper to be shredded. Three
minutes after shredding, the cutter automatically stops rotating.
Set-up Guidelines
1. Install the shredder on a level surface, away from heat sources & direct sunlight.
2. Insert plug into wall outlet with the appropriate voltage, 110V. If the outlet
is shared with another electronic device, the total current should not exceed 30A
(at 110V).
Specifi cations
Cutting Style:
Cross Cut
Shred Size:
5/32” x 1-5/8”
Sheet Capacity:
35 to 40
Speed:
11 feet per minute
Feed Opening:
9.4”
Dimensions:
20” W x 20” D x 36” H
Bin Capacity:
21 gal.
Weight:
177 lbs.
Power supply:
110-120V, 60Hz
Cutting heads accept credit cards, staples, paper clips, CDs,
DVDs and digital video tape.
4.
Reverse Operation
Push the “REV” button and the signal lamp “REV” will light and cutters will operate
in reverse. If too much paper is inserted at one time in standard modes, the
shredder will automatically operate in reverse. If this occurs, remove the inserted
paper and shred in smaller amounts. NOTE: The maximum amount of paper to be
shredded differs according to paper quality, humidity and voltage. If the shredder is
to be used continuously, do not insert more than half of the maximum capacity.
5.
Full Sensor
If the waste bin is full, the “FULL” lamp will light and the cutter will stop
automatically. Open the door, empty the waste bin of paper strips/chips, replace
FD 8702CC
Safety Precautions
To avoid personal injury, and damage to the shredder, observe the following safety
precautions. Please keep these instructions for future reference.
NOTE:
In case of emergency, push the
“Power Switch” to cut off power and/or
pull the plug out of the wall outlet.
•
Keep hands, long hair, clothing, ties, jewelry
and loose items away from the feed opening
and shred outlet.
•
Do not use the shredder for anything other
than its intended purpose. Never use it to shred cloth, plastic, cardboard or any
hard material that will cause damage to the shredder blades.
•
Do not allow children to use the machine.
•
Do not operate with a damaged power cord or plug, or when the machine is
damaged in any manner.
•
Unplug the shredder when it is being moved, or if it is not in use for an extended
period of time.
•
Do not disconnect the power by pulling only the cord. Hold the plug when
disconnecting.
•
Keep the shredder away from direct sunlight.
•
Do not sit on the shredder or place anything on top of it.
•
Never open the fi xed switch or cover.
