Formax FD 215S, Operator'S Manual

Page: 4 / 6

2
SETUP
1. Plug in and turn on the creaser. Be sure the red power indicator light is
on.
2. Using the Changeover Switch (Fig. 1), choose the operating mode:
2a. With switch in upper position (-), the creaser is in Manual Mode. The
creaser will crease one time, with a single touch of the switch, and will
automatically return to the center position (0).
2b. With the switch in the center position (0), the machine is in standby but
not operating.
2c. With the switch in the lower position (=), the creaser is in Semi-Automatic
Mode. After inserting the paper, the machine will crease one time after
the foot pedal is pressed, then will return to standby mode.
It is suggested to leave the switch at (=) for Semi-Automatic Mode.
Remove the foot-control pedal from the box and attach it to the foot pedal switch on the Operation Panel. Be sure to align
the pins correctly to avoid damage. Place the foot pedal on the floor.
Remove the power cord from the box and plug into the Power Inlet on the Operation Panel. Be sure the voltage from the
wall outlet matches the voltage of the creaser.
1 Machine Data Panel
2 Foot Pedal Switch Jack
3 Operation Mode Changeover Switch
4 Power Switch with Light
5 Power Inlet with Fuse
1 2 3 4 5
OPERATION
3. Loosen thumbscrews on each side guide (Fig. 2).
4. Slide side guides to correct location based on desired
placement of crease. When moving the side guides, lift
gently while sliding to avoid damage to the guide rail.
5. Tighten thumbscrews.
Manual Mode
Semi-Automatic Mode
Fig. 1
Fig. 2