40
5.4.3
Adjust Side Guides
Adjust the side guides:
1. Take a stack of documents/B
REs and place them
in the feeder tray.
BREs with flap down and leading (top side
pointing to system).
2. Adjust the side guides by turning the thumb
wheel
G
so the documents/BREs just fit and can
move without resistance.
Too much play causes skewing.
5.4.4
Document Separation
When the
Production
Feeder is used a
s
an automatic
separation feeder, the separation is set
automatically.
The
Production
Feeder can also be used on a feeder
position with a manually adjusted separation.
To adjust, proceed as follows:
1. Remove feeders 2 and 3.
Note
The lowest feeder is feeder 1.
2. Squeeze the two blue handles
C
and
D
and shift
the feeding plate
F
as far as possible to the front.
3. Push knob
E
forward until it clicks.
4. Place a document/BRE on the feeder tray and slide it in the system till the leading
edge is not visible anymore. Turn knob
E
counterclockwise if the separation is set to
o
narrow.
5. Push the document/BRE between the rollers.
6. Turn knob
E
clockwise to get more resistance and counterclockwise if the separation is
set to
o
narrow.
The separation is adjusted correctly when a slight resistance is felt on the document/
BRE.
7. Pull knob
E
back when ready.
8. Remount feeders 2 and 3.
5.4.5
Feeding Documents
To feed documents:
1. Squeeze the two blue handles
C
and
D
.
2. Shift the feeding plate
F
to the rear position.
G
H
I
J
C
D
F
E
Summary of Contents for 6304 Series
Page 1: ...6304 Series Inserter OPERATOR MANUAL Rev 1 2010...
Page 2: ......
