7.
Peel and fold the small anti abrasion film pad in half over the hood edge between the fingers on the pedestal. Push a metal mounting bracket
over the hood edge on top of the anti abrasion pad installed previously. Ensure the bracket is fully engaged over the hood edge and the hole
in the bracket is aligned with the hole in the pedestal.
8.
Place the protector on the pedestals and drop a pin through the protector and into the pedestal. Maintain slight pressure on the pin, to ensure
proper seating of the components, while simultaneously tightening the screw. Repeat for remaining pedestal locations.
9.
Peel and fold large anti-abrasion film pad in half over the edge of the hood, underneath each of the four (4) outermost holes in the protector.
See Illustrations #2 – Step 9.
10.a) Place a clip over each of the anti-abrasion film pads on the edge of the hood as shown below in
Illustration #2 – Step 10a
.
b) Insert a pin through the protector into each of the clips.
See Illustration #2 – Step 10b.
c) Insert the #6 x 5/8
’’ screw through an ‘L’- bracket and into the clip.
See Illustration #2 – Steps 10c & 10d.
d) Make sure all the components are well seated together; the protector is centered on the hood, and then tighten the screws into the clips.
11. On some vehicles it may be necessary to adjust the hood bumpers and/or latch for proper clearance.
Note: Do not pull on the protector when opening or closing the hood.
Illustration #1: Pedestals and Bumpons Location
Care Instructions
Clean the protector with a mild soap and water solution or plastic cleaner only. Do not use chemicals or solvents.
Periodically
checks to make sure that the bumpons are in place and that the protector is secure.
Avoid using automatic car washes.
Do not pull on the
protector when opening or closing the hood.
Thank you for purchasing a FormFit hood protector. Retain this sheet for care Instructions and kit information.
Replacement hardware kits are available from your local FormFit dealer.
Made in Canada
Rev0.151708
Illustration #2: Clip Configuration – Patent No. 6,892,427
Step #9
Step #10a
Step #10b
Step #10c & 10d
90mm
600mm
25mm
210mm
350mm 350mm
