19
EN
Precautions for use
•Comply with the use-by dates of your hose,
and replace it if need be. Test the tightness
every time the hose is replaced.Check the
position of the connecting hose to ensure
that it is not in contact with the hot parts of
the appliance.
•Be sure to replace the container away from
any source of ignition.
•Do not plug the vents and regularly check
that they are clean. If the venturis are
clogged, contact the manufacturer or your
retailer.
•The underside of the appliance must remain
clear to allow for proper circulation of air to
the burner.
•Do not modify the appliance, contact the
manufacturer or your retailer.
•Before using your FORGE ADOUR plancha
after a period of storage and/or inactivity,
check it carefully in order to detect any gas
leak and/or clogging of the burners.
•Do not modify the appliance, contact the
manufacturer or your retailerin of doubt or
fault.
•Before using your FORGE ADOUR plancha
after a period of storage and/or inactivity,
check it carefully in order to detect any gas
leak and/or clogging of the burners.
•The following operation in particular are
considered wrong and dangerous use of the
appliance :
- Use of coal, wood or fuel other than liquid
gas butane, propane or their mixtures.
- Use of the plancha as heater.
Directions for use
LIGHTING AND OPERATION OF PLANCHA
Before lighting your plancha, check that
all the conditions stated in the “PRECAU-
TIONS FOR USE” section are met.
•Check that the control switch si on the “0”
positioin as shown (Fig.1). Open the gas
supply
•Rotate the xontrol switch counterclockwise
while holding it down. (Fig.2)
•While still holdong the control switch
down, keep pressing on the ignition to
generate the sparks required for lighting of
the burners.
•Keep the control switch down for at least
5 seconds after lighting the burner. If the
burner has not ignited, stop acting on the
device, open the enclosure door and / or
wait at least 1 min before attempting to
light the burner again.
Control switch
Piezzo
Control switch
Piezzo